Passengers Weight Sensor Replacement

Passenger's Weight Sensor Replacement

Removal ('06-09 models)

NOTE: Removal of the passenger's weight sensors must be performed according to the precautions/procedures described at the beginning of the SRS. Technician Safety Information

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the passenger's seat assembly. Removal and Replacement

3. Remove the 6 mm TORX bolts (A) and 8 mm TORX bolts (B) attaching the seat track (C) to the passenger's weight sensors (D).

4. Disconnect the sensors connectors (E) from the passenger's weight sensor unit (F), then remove the passenger's weight sensors.






Installation

NOTE: Be sure to install the harness wires so they are not pinched or interfering with other parts.

1. Install the passenger's weight sensors with 6 mm TORX bolts (A) and 8 mm TORX bolts (B) under the seat track.

2. Connect the sensors connectors (C) to the passenger's weight sensor unit (D).

3. Reinstall the passenger's seat. Removal and Replacement

4. Do the battery terminal reconnection procedure. Procedures

5. Clear any DTCs. Initial Inspection and Diagnostic Overview

6. Calibrate the passenger's weight sensor unit.

7. Confirm proper operation: Turn the ignition switch to ON (II); the SRS indicator should come for about 6 seconds and then go off.