Passengers Weight Sensor Unit Replacement

Passenger's Weight Sensor Unit Replacement

Removal ('06-09 models)

NOTE: Review the seat replacement procedure in the body section Removal and Replacement before performing repair or service.

1. Slide the seat all the way to the rear.

2. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

3. Disconnect the connectors (A). Remove the mounting bolts (B) and the passenger's weight sensor unit (C) from the seat riser.






Installation

NOTE: Be sure to install the harness wires so they are not pinched or interfering with other parts.

1. Place the passenger's weight sensor unit (A) on the seat riser. Tighten the two mounting bolts (B) and connect the connectors (C).

2. Do the battery terminal reconnection procedure. Procedures

3. Clear any DTCs. Initial Inspection and Diagnostic Overview

4. Calibrate the passenger's weight sensor unit.

5. Confirm proper operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.