Auto Aiming Operation Check (Function Test)

ACTIVE AFS


Auto Aiming Operation Check (Function Test)

1.CHECK AIMING MOTOR
CONSULT-III ACTIVE TEST
1. Start engine and turn lighting switch to 2ND position.
2. Select "LEVELIZER TEST" of ADAPTIVE LIGHT active test item.
3. Touch "ORIGIN" and "PEAK" screen.
4. Make sure of auto aiming operation.





OK or NG
OK - GO TO 2.
NG -
- When interference or poor fitment is found, perform aiming adjustment. Adjustments. If it is normal, replace headlamp. Active AFS.
- When the operation range is irregular, perform aiming adjustment. Adjustments. If it is normal, GO TO 4.
2.PERFORM STATE LEVELIZER ADJUSTMENT 1
CONSULT-III DATA MONITOR
Check "LEV ACTR VLTG" in "Data Monitor" with unloaded vehicle position. (Remove all loads in driver, passenger and trunk rooms.)





OK or NG
OK - GO TO 3.
NG - Perform LEVELIZER ADJUSTMENT. CONSULT-III Function (Adaptive Light).
3.PERFORM STATE LEVELIZER ADJUSTMENT 2
CONSULT-III DATA MONITOR
Check if "LEV ACTR VLTG" changes approx. 3 seconds after lowering vehicle height as low as approx. -0.5V from the value of "HI SEN OTP RR" in "Data Monitor" at unloaded vehicle position. (Remove all loads in driver, passenger and trunk rooms.)
OK or NG
OK - GO TO 4.
NG - Perform LEVELIZER ADJUSTMENT. CONSULT-III Function (Adaptive Light).
4.CHECK HEIGHT SENSOR SIGNAL AND AIMING MOTOR DRIVE SIGNAL
CONSULT-III DATA MONITOR
Remove height sensor link bracket mounting nuts (rear stabilizer side). For details, Service and Repair. Change sensor angle from the basic point of sensor angle 0� (standard position) and check "HI SEN OTP RR" and "LEV ACTR VLTG" of "Data Monitor".





















OK or NG
OK - Auto aiming operation function is normal.
- � When approx. 4.5 V or 0.5 V is not displayed on "HI SEN OTP RR" screen with sensor angle
NG approx. 45� or -45�, check connector for connection, bend and loose fit. If it is normal, replace height sensor. Service and Repair.
- When "HI SEN OTP RR" value is normal but "LEV ACTR VLTG" value differs from maximum/ minimum angle of auto aiming operation, replace AFS control unit. Service and Repair.
- When "LEV ACTR VLTG" value is normal but operation range is irregular, check aiming motor system circuit. .