CONSULT-III Function (Adaptive Light)

ACTIVE AFS


CONSULT-III Function (ADAPTIVE LIGHT)

CONSULT-III can display each diagnostic item using diagnostic test modes shown following.






WORK SUPPORT (STEERING ANGLE SENSOR ADJUSTMENT)

Work Support Item List






Notes on Steering Angle Sensor (Neutral Point) Adjustment
- Be sure to adjust steering angle sensor neutral point before driving if any of the following has been removed/installed or replaced: Steering angle sensor; Steering system part, Suspension system part.
- On vehicle with VDC, perform steering angle sensor neutral point adjustment only on VDC side. Never perform the adjustment on ADAPTIVE LIGHT side as this may lead to VDC malfunctions. If the adjustment has been performed on AFS side, readjust on VDC side. For steering angle sensor neutral point adjustment procedures on VDC side, in "ON-VEHICLE SERVICE".
- When replaced steering angle sensor, AFS control unit detects "DTC C1026 ST ANG SEN SIG". Delete the malfunction history after adjust steering angle sensor on VDC side.
- Steering angle sensor neutral point adjustment should be performed using CONSULT-III. (The adjustment will not be possible without CONSULT-III.)

Operation Procedure
.

WORK SUPPORT (LEVELIZER ADJUSTMENT)

Work Support Item List






SELF-DIAG RESULTS

CAUTION:
DTC B2503 and B2504 cannot be detected before the swivel operation. Thus, perform swivel operation first, and then check the display in self-diagnostic results.

Description of DTC and Solutions after Detection
CONSULT-III can detect DTC (Diagnosis trouble code). The descriptions and solutions of DTC are listed below.
















DATA MONITOR

Data Monitor item






ACTIVE TEST

CAUTION:
Can be tested only when swivel actuator initialization is completed. If initialization is not completed, "RETRY COMMAND" is displayed and cannot be tested.
- LOW BEAM TEST RIGHT
Low beam headlamp (right) can be operated to swivel angle 0� by touching "ORIGIN", and to maximum angle by "PEAK".





- LOW BEAM TEST LEFT
Low beam headlamp (left) can be operated to swivel angle 0� by touching "ORIGIN", and to maximum angle by "PEAK".





- LEVELIZER TEST
Aiming motor drive signal can be changed to approx. 85% (ratio to IGN power supply) by touching "ORIGIN", and to approx. 15% by "PEAK". That angles headlamp LO up and down.