Manifold Pressure/Vacuum Sensor: Service and Repair

Manifold Absolute Pressure (MAP) Sensor

Removal
1 Remove the cover and disconnect the battery ground cable. For additional information, refer to Specifications [1][2]Battery
2 Remove the engine cover. For additional information, refer to Engine Cover Service and Repair




3 Release the wiring harness from the rear of the engine.
- Remove the 2 bolts.
4 Disconnect the MAP sensor electrical connector.




5 Remove the MAP sensor.
- Remove the 2 Torx screws.
- Remove and discard the O-ring seal.

Installation
1 Install the MAP sensor.
- Clean the component mating faces.
- Install a new O-ring seal.
- Tighten the Torx screws.
- Connect the electrical connector.
2 Attach the wiring harness.
- Tighten the bolts to 10 Nm (7 lb.ft).
3 Install the engine cover. For additional information, refer to Engine Cover Service and Repair
4 Connect the battery ground cable and install the cover. For additional information, refer to Specifications [1][2]Battery