Consult-III Function (Transmission)

CONSULT-III Function (TRANSMISSION)
CONSULT-III can display each diagnostic item using the diagnostic test modes shown below.

FUNCTION:

CONSULT-III REFERENCE VALUE (Part 1):

CONSULT-III REFERENCE VALUE (Part 2):

CONSULT-III REFERENCE VALUE (Part 3):

WORK SUPPORT MODE

Display Item List:

Engine Brake Adjustment
1. Touch "WORK SUPPORT".
2. Touch "ENGINE BRAKE ADJ".
3. Touch "START".
4. Set "ENGINE BRAKE LEVEL" by touching "UP" or "DOWN".
"ENGINE BRAKE LEVEL"
0: Initial set value (Engine brake level control is activated)
OFF: Engine brake level control is deactivated.
5. Turn ignition switch OFF, wait at least 5 seconds and then turn ignition switch ON.
6. Engine brake level set is completed.

CAUTION: Mode of "+1" "0" "-1" "-2" "OFF" can be selected by pressing the "UP""DOWN" on CONSULT-III screen. However, do not select mode other than "0" and "OFF". If the "+1" or "-1" or "-2" is selected, that might cause the irregular driveability.

Check CVT Fluid Deterioration Date
1. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen.
2. Touch "CONFORM CVTF DETERIORTN".
3. Check "CVTF DETERIORATION DATE".
"CVTF DETERIORATION DATE"
More than 210000:
It is necessary to change CVT fluid.
Less than 210000:
It is not necessary to change CVT fluid.

CAUTION: Touch "CLEAR" after changing CVT fluid, and then erase "CVTF DETERIORATION DATE".

SELF-DIAGNOSTIC RESULT MODE
After performing self-diagnosis, place check marks for results on the CVT-28, "How to Perform Trouble Diagnosis for Quick and Accurate Repair". Reference pages are provided following the items.

Operation Procedure
1. Touch "SELF-DIAG RESULTS".
Display shows malfunction experienced since the last erasing operation.

Display Items List (Part 1):

Display Items List (Part 2):

Display Items List (Part 3):

How to Erase Self-diagnostic Results
1. Touch "SELF-DIAG RESULTS".
2. Touch "ERASE". (The self-diagnostic results will be erased.)

DATA MONITOR MODE

Operation Procedure
1. Touch "DATA MONITOR".

NOTE: When malfunction is detected, CONSULT-III performs "REAL-TIME DIAGNOSIS". Also, any malfunction detected while in this mode will be displayed at real time.

Display Items List (Part 1):

Display Items List (Part 2):

Display Items List (Part 3):

Display Items List (Part 4):

CAN DIAGNOSTIC SUPPORT MONITOR MODE

Operation Procedure
1. Touch "CAN DAIG SUPPORT MNTR". Refer to LAN-38, "CAN Diagnostic Support Monitor". CAN Diagnostic Support Monitor