Cannot Be Changed to Manual Mode

Cannot Be Changed to Manual Mode

SYMPTOM:
Does not change to manual mode when manual shift gate is used.

DIAGNOSTIC PROCEDURE

1. CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis check. Refer to CVT-44, "CONSULT-III Function (TRANSMISSION)". Consult-III Function (Transmission)
Is any malfunction detected by self-diagnosis?
YES >> Check the malfunctioning system. Refer to CVT-44, "CONSULT-III Function (TRANSMISSION)". Consult-III Function (Transmission)
NO >> GO TO 2.

2. CHECK MANUAL MODE SWITCH
Check the manual mode switch circuit. Refer to CVT-107. P0826
OK or NG
OK >> GO TO 3.
NG >> Repair or replace damaged parts.

3. SYMPTOM CHECK
Check again. Refer to CVT-40, "Cruise Test". Cruise Test
OK or NG
OK >> INSPECTION END
NG >> GO TO 4.

4. CHECK TCM
1. Check TCM input/output signals. Refer to CVT-41, "TCM Input/Output Signal Reference Value". TCM Input/Output Signal Reference Value
2. If NG, re-check TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.