Operation CHARM: Car repair manuals for everyone.

433419 Removing and installing sensor for body


WM 433419 Removing and installing sensor for body

Preliminary work

Information

These instructions for removal and installation describe all the sensors for the body (two sensors at the front, one sensor at the rear).

Installation position at front: Position 8, under the left and right wings.

Installation position at rear: Position 8, under the boot floor plate on the right (sensor can be accessed from the interior.).





Front sensor
1. Lift the vehicle. -> 40 Lifting the vehicle
2. Remove wheel housing liner. -> 505619 Removing and installing front wheel housing liner Service and Repair

Rear sensor

Information

For removing and installing the rear sensor, it is not necessary to lift the vehicle.

The rear sensor can be accessed from the interior.

1. Remove boot floor plate (centre part) and remove only the right side cover. -> 700619 Installing and removing luggage compartment trim (loadspace cover) Service and Repair

Removing

Front sensor
1. First push together the sensor connector -arrow- firmly (makes removal easier.). Lift connector lock and then remove connector.





Sensor for body at front

2. Loosen screw of holder and remove sensor.

Rear sensor
1. First push together the sensor connector -arrow- firmly (makes removal easier.). Lift connector lock and then remove connector.





Sensor for body at rear

2. Loosen nut of holder and remove sensor.

Installing

Front sensor
1. Insert sensor with holder in the correct position -arrow- and tighten the fastening screw.





Sensor for body at front

2. Plug in connector. Pay attention to correct line routing.

Rear sensor
1. Insert sensor with holder in the correct position -arrow- and tighten the fastening nut.





Sensor for body at rear

5. Plug in connector. Pay attention to correct line routing.

Subsequent work

Front sensor
1. Install wheel housing liner. -> 505619 Removing and installing front wheel housing liner Service and Repair

Rear sensor
2. Fit right side cover and install the boot floor plate (centre part). -> 700619 Installing and removing luggage compartment trim (loadspace cover) Service and Repair