976719 Removing and installing wire harness in rear lid

WM 976719 Removing and installing wire harness in rear lid

Preliminary work

Preliminary work for wire harness in rear lid

Remove trim panel for rear lid. -> 708719 Removing and installing rear lid trim panel - section on "removing" 708719 Removing and installing trim panel for rear lid

Remove trim panel for tailgate or trim panel for rear lid. -> 709219 Removing and installing trim panel for tailgate - section on "Removing"

Remove lid hinge cover. -> 709119 Removing and installing rear lid hinge trim panel - section on "Installing" 709119 Removing and installing rear lid hinge trim

Remove C-pillar trim panel, left side. -> 706819 Removing and installing C-pillar trim panel - section on "Removing" 706819 Removing and Installing C-Pillar Trim Panel

Loosen headliner in rear area. -> 708419 Removing and installing headliner - section on "Removing" Service and Repair

Removing wire harness in rear lid





Installation position





1. Switch off ignition and remove ignition key.
2. Disconnect electric plug connection -A-E -.
3. In area of left C-pillar, release both electric plug connections -F- - wire harness for rear lid to main wire harness - -A- and disconnect.





Releasing plug connections

4. Unclip wire harness on roof and pull to the rear out of the "inner roof" area.





Removing wire harness on roof

5. Unclip wire harness on rear lid -A, B- , press out the rubber covers for the rear lid wire harness, pull the wire harness out through the lid -C- and remove.





Removing wire harness from lid

Installing wire harness in rear lid





Installation position





1. Route plug connections from the passenger compartment wire harness in the rear lid and press in the two rubber sleeves in the rear lid.





Routing wire harness in rear lid

2. Position wire harness on rear lid and clip in.





Positioning wire harness on rear lid and clipping in

3. Route wire harness through the roof opening, press on the rubber sleeve, route the wire harness in the roof and fix with two clips.





Routing harness in roof

4. Route the harness along the C-pillar and connect to the passenger compartment harness -F-.





Routing harness in C-pillar

5. Insert electric connectors -A - E-.





Overview of plug connections

6. Electrical loads: Check operation of auxiliary stop light, rear window heating, interior light, wiper motor.

Subsequent work

Subsequent work for wire harness in rear lid

Install headliner in rear area. -> 708419 Removing and installing headliner - section on "Installing" Service and Repair

Install C-pillar trim panel, left side. -> 706819 Removing and installing C-pillar trim panel - section on "Installing" 706819 Removing and Installing C-Pillar Trim Panel

Install lid hinge cover. -> 709119 Removing and installing rear lid hinge trim panel - section on "Installing" 709119 Removing and installing rear lid hinge trim

Remove trim panel for tailgate or trim panel for rear lid. -> 709219 Removing and installing trim panel for tailgate - section on "Installing"

Remove rear lid trim panel. -> 708719 Removing and installing rear lid trim panel - section on "Installing" 708719 Removing and installing trim panel for rear lid