914319 Removing and installing reversing camera
WM 914319 Removing and installing reversing camera
Tools
Technical values
Preliminary work
1. If the reversing camera has to be removed and installed, the reversing camera must be calibrated using PIWIS Tester II 9818. -> 9100K2 Calibrating reversing camera
2. If the reversing camera has to be replaced, the values/data must be read out of the reversing camera control unit before removing the reversing camera. -> 914355 Replacing reversing camera 914355 Replacing reversing camera.
3. Remove lower part of trim panel for tailgate. -> 709219 Removing and installing trim panel for tailgate - section on "Removing" Service and Repair.
Removing reversing camera
Installation position of reversing camera
1. Unclip electric plug connections -1 + 2- from the bracket.
Unclipping connector for reversing camera from bracket
2. Release two electric plug connections -1 + 2- and pull them off -a- ( -A- ).
Pulling off connectors on reversing camera
3. Screw off two fastening nuts -1- for the rear lid release -A-.
Removing release
4. Unplug electric plug connection -B-.
5. Press reversing camera at the pins -1- outwards -A-.
Removing reversing camera
6. Pull wiring -2- through the opening in the tailgate -B-.
Installing reversing camera
1. The reversing camera is installed in reverse order to removal.
2. Tighten two fastening nuts on the reversing camera to => Tightening torque: 6 Nm (4.5 ftlb.).
Subsequent work
1. Install lower part of trim panel for tailgate. -> 709219 Removing and installing trim panel for tailgate - section on "Installing" Service and Repair
2. If the reversing camera was replaced, the values/data must be written back into the reversing camera control unit using PIWIS Tester II 9818 after removing the reversing camera. -> 914355 Replacing reversing camera 914355 Replacing reversing camera.
3. If the reversing camera was removed and installed, the reversing camera must be calibrated using PIWIS Tester II 9818. -> 9100K2 Calibrating reversing camera