586319 Removing and Installing Rubber Seal for Rear Door
WM 586319 Removing and installing rubber seal for rear door
Preliminary work
1. Remove rear inner door entry guard. -> 680519 Removing and installing inner door entry guard - section on "Removing"
2. Remove B-pillar trim but not the seat belt. -> 706719 Removing and installing B-pillar trim - section on "Removing" 706719 Removing and installing B-pillar trim
3. Remove rear grab handle. -> 683719 Removing and installing rear grab handle - section on "Removing" 683719 Removing and installing rear handle
4. Remove C-pillar trim but not the seat belt. -> 706819 Removing and installing C-pillar trim - section on "Removing" 706819 Removing and installing C-pillar trim
5. Remove the rear side trim panel. -> 707519 Removing and installing rear side trim panel - section on "Removing" 707519 Removing and installing rear side trim panel
Removing rubber seal for rear door
1. Detach rooflining -1- in the area of the rubber seal for the rear door -2-.
Detaching rooflining
2. Pull off rubber seal all around the sheetmetal flange.
Removing rubber seal for rear door
Installing rubber seal for rear door
1. Fit vulcanisation point of rubber seal -1- close to the door arrester on the sheetmetal flange.
Positioning rubber seal for rear door
The air vents in the seal must be facing the outside of the vehicle.
2. Press rubber seal onto the sheetmetal flange all the way around.
Installing rubber seal for rear door
3. Check that the seal is installed correctly.
3.1. Pay particular attention to the areas near the tight roundings for correct installation; there must be no deformation or stretching.
3.2. Check the air vents; they must not be closed or covered.
4. Insert rooflining into the rubber seal.
Inserting rooflining into rubber seal for rear door
Subsequent work
1. Install rear inner door entry guard. -> 680519 Removing and installing inner door entry guard - section on "Installing"
2. Install B-pillar trim but not the seat belt. -> 706719 Removing and installing B-pillar trim - section on "Installing" 706719 Removing and installing B-pillar trim
3. Install rear grab handle. -> 683719 Removing and installing rear grab handle - section on "Installing" 683719 Removing and installing rear handle
4. Install C-pillar trim but not the seat belt. -> 706819 Removing and installing C-pillar trim - section on "Installing" 706819 Removing and installing C-pillar trim
5. Install the rear side trim panel. -> 707519 Removing and installing rear side trim panel - section on "Installing" 707519 Removing and installing rear side trim panel