Procedures

WM 340135 Checking and topping up transmission oil

Tools





Technical values





Preliminary work

Preliminary work for transmission oil

1. Remove engine guard. -> 108019 Removing and installing engine guard - section on "Removing" 108019 Removing and installing engine guard

Checking transmission oil

WARNING

Hot fluid

- Danger of scalding

-> Let the fluid cool down.
-> Wear personal protective gear.

Information

- Secure vehicle to prevent it rolling away.

- To check transmission oil the vehicle must be horizontal.

1. Unscrew oil inspection plug -arrow-.





Oil inspection plug

2. The oil level is correct if the oil reaches the lower edge of the inspection window.
If this is not the case, add more transmission oil. -> 340135 Checking and topping up transmission oil - section on "Topping up"
3. Screw in oil inspection plug -arrow- with a new sealing ring. => Tightening torque: 35 Nm (26 ftlb.)





Oil inspection plug

Topping up transmission oil

WARNING

Hot fluid

- Danger of scalding

-> Let the fluid cool down.
-> Wear personal protective gear.

Information

- Secure vehicle to prevent it rolling away.

- To check transmission oil the vehicle must be horizontal.

1. Unscrew oil inspection plug -arrow-.





Oil inspection plug

Information

Use only oil approved by Porsche.

2. Use manual metering pump WE 1372 to fill in oil up to the lower edge of the oil inspection plug -arrow-.
3. Screw in oil inspection plug -arrow- with a new sealing ring. => Tightening torque: 35 Nm (26 ftlb.)

Subsequent work

Subsequent work for transmission oil

1. Install engine guard. -> 108019 Removing and installing engine guard - section on "Installing" 108019 Removing and installing engine guard