Checking Pedal Sensor [EK6]

Checking Pedal Sensor

- Ignition off.
- Disconnect control module.





First connect a temporary lead between test box #1 and #34.

Then connect other temporary leads between #2, #21, #36 and #1 on test box.

Connect an ohmmeter between #16 and #41 on test box.

NOTE: When the ignition is switched on, the outlet valves open. To prevent valves overheating, do not leave ignition on for more than 20 seconds. Wait at least 30 seconds before next test.

- Ignition on.





- Push brake pedal right down and hold it there or block it in that position.





- Ignition off.





Ohmmeter should read infinite resistance (position 7) on the pedal sensor.





- Release brake pedal gently and read off ohmmeter. Ohmmeter should read resistance value as per the table.

- Remove the temporary leads.

If readings are OK:
- Test drive EK7. Test Drive [EK7]

If any reading is incorrect:
- Try another pedal sensor as per LE. Pedal sensor, replacement. Service and Repair