Front Passenger's Airbag Replacement

Front Passenger's Airbag Replacement

NOTE: If replacing the front passenger's airbag after deployment, refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the glove box. Glove Box Removal/Installation

3. Disconnect the dashboard wire harness 4P connector (A) from front passenger's airbag.






4. Remove the passenger's dashboard duct (A), then detach the harness clips (B).






5. Remove the mounting nuts (A) and mounting bolts (B). Release the hooks of the hook plate (C), then remove it.

6. Remove the front passenger's airbag (D) from the dashboard panel.






Installation

1. Place the front passenger's airbag (A) into the dashboard panel, then install the hook plate (B).
NOTE: Make sure the hooks are set properly.

2. Tighten the front passenger's airbag mounting nuts (C) and bolts (D).






3. Install the harness clips (A), then reinstall the passenger's dashboard duct (B).






4. Connect the dashboard wire harness 4P connector (A) to the front passenger's airbag, then reinstall the glove box. Glove Box Removal/Installation

5. Do the battery terminal reconnection procedure. Procedures

6. Clear any DTCs with the HDS. Initial Inspection and Diagnostic Overview

7. After installing the airbag, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.