Windshield Washer Fluid Reservoir

Windshield Washer Fluid Reservoir

Special tools, testers and auxiliary items required

• Drip tray

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Removing

- Switch off ignition and remove ignition key.

- Remove the washer fluid reservoir filler neck. Refer to => [ Windshield Washer Fluid Reservoir Filler Neck ] Windshield Washer Fluid Reservoir Filler Neck.

- Remove left front wheel.

- Remove left front wheel housing liner.

- Place a drip tray under the windshield washer fluid reservoir.





- Remove the hose coupling - 1 - from the headlamp washer system fluid line - 3 - by pulling the release button.

- Cut through the cable ties - 2 - and - 4 -.

- Remove the plastic wedge - 5 -.

- Disconnect the electrical connectors - 7 - and - 8 -.





- Release the securing clip and remove the washer fluid line - 9 - from the windshield washer system washer fluid pump.

- Loosen the wiring harness - 2 - from the mounts on the washer fluid reservoir.

- Remove screws - 1 - and - 3 -.

- Pull the washer fluid reservoir forward slightly and out.

- Disconnect the electrical connector - 5 -.

- Loosen the headlamp washer system fluid hose - 6 - and wiring harness - 4 - from the mounts on the washer fluid reservoir.

- Remove the washer fluid reservoir.

Installing





• Tightening Specifications and Sequence => [ Washer fluid reservoir, tightening
specifications and sequence ] Windshield Washer Fluid Reservoir, Washer Fluid Lines and Nozzle Assembly Overview.

- When inserting the washer fluid reservoir, make sure the securing tab - 1 - engages in the mount - 2 - on the fender.

Install in reverse order of removal, observing the following:

- Install left front wheel house liner.

- Install the washer fluid reservoir filler neck. Refer to => [ Windshield Washer Fluid Reservoir Filler Neck ] Windshield Washer Fluid Reservoir Filler Neck.