Brake Pedal

Brake Pedal

Removing

- Move the seat all the way back as far as it will go.

- Switch the ignition off.

- Remove the storage compartment under the instrument panel on the driver side.

- Remove the footwell vent.

- Disconnect the connector from the brake lamp switch (F).

- Remove the brake lamp switch. Refer to => [ Brake Lamp Switch ] Service and Repair.

- Disconnect brake pedal from brake booster. Refer to => [ Brake Pedal and Brake Booster, Disconnecting and Connecting ] Brake Pedal and Brake Booster, Disconnecting and Connecting.

• If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp switch if the brake pedal is released too quickly.

- Remove the bolt - 3 -.






• Remove both clips - 1 -.

- Remove both clips from the bolt.

- Remove the bolt - 5 - from the brake pedal - 2 - and bracket - 4 -.

- Remove brake pedal.

If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp switch if the brake pedal is released too quickly.

Installing

- Install the brake pedal in the pedal bracket.

- Remove the bolt - 5 - through the brake pedal - 2 - and bracket - 4 -.






- Install both clips - 1 - on the bolt.

• Make sure the left and right clips - 1 - fit securely inside the groove on the bolt.






- Install the bolt - 3 - and tighten to 8 Nm.

Brake Pedal and Brake Booster, Connecting

- Hold ball head of push rod in front of mounting and push brake pedal in direction of brake booster, so the ball head locates audibly.

- Install the brake lamp switch. Refer to => [ Brake Lamp Switch ] Service and Repair

- Install the footwell vent.

• Make sure the brake lamp switch is working correctly before driving the vehicle.

Make sure the brakes are working correctly before driving the vehicle for the first time.