Washer Fluid Reservoir

Washer Fluid Reservoir

Observe notes on contact corrosion. Refer to=> [ Contact Corrosion ] Service Precautions.

Removing






- Remove the washer fluid reservoir filler neck. Refer to=> [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Remove the left front wheel housing liner..

- Open the clip - arrow - and remove the windshield washer fluid hose - 1 - from the windshield washer pump.

- Disconnect the connectors - 2 and 4 -.

- Remove the wiring harness - 5 - and the windshield washer fluid hose from the mounts on the windshield washer fluid reservoir.

- Remove the bolts - 3 and 6 -.

- Swivel the lower windshield washer fluid reservoir forward just a little.

- Disconnect the electrical connector - 3 -.






- Open the clip - arrow - and remove the washer fluid hose - 2 - for the headlamp washer system from the hose coupling.

- Remove the windshield washer fluid reservoir - 1 -.

Installing






• Tightening specifications and sequence, refer to=> [ Washer Fluid Reservoir,
Tightening Specifications and Sequence ] Windshield Washer Fluid Reservoir, Lines and Nozzle Overview.

Install in reverse order of removal. Note the following:

- When inserting the washer fluid reservoir, make sure the securing tab - 1 - engages in the mount - 2 - on the fender end plate.

- Install the front wheel housing liner..

- Install the washer fluid reservoir filler neck. Refer to=> [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.