Seat Position Sensor: Service and Repair

Driver's Seat Position Sensor Replacement

Removal ('06-09 models)

NOTE:

- Removal of the driver's seat position sensor must be performed according to the precautions/procedures. Technician Safety Information

- Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the driver's seat assembly. Removal and Replacement

3. Disconnect the rear harness 2P connector (A) from the driver's seat position sensor (B).

4. Using a TORX T30 bit, remove the TORX bolt (C), then remove the driver's seat position sensor.






Installation

NOTE:

- Be sure to install the harness wires so they are not pinched or interfering with other parts.

- Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.

- After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.

1. Install the driver's seat position sensor with a new TORX bolt (A), then connect the rear harness 2P connector (B) to the driver's seat position sensor (C).

2. Install the driver's seat assembly. Removal and Replacement

3. Do the battery terminal reconnection procedure. Procedures

4. Clear any DTCs. Initial Inspection and Diagnostic Overview

5. Check the operation of the driver's seat position sensor with the HDS. Drivers Seat Position Sensor Operation Check