Steering Angle Sensor: Service and Repair

Steering Angle Sensor Replacement

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE: Do not damage or drop the combination switch as the steering angle sensor is sensitive to shock and vibration.

1. Do the 12 volt battery terminal disconnection procedure Procedures.

2. With the front wheels in the straight-ahead position and the steering wheel centered, then remove the steering wheel Steering Wheel Removal.

3. Remove the steering column covers Steering Column Cover Removal/Installation.

4. Disconnect the combination light switch 12P connector (A) and the steering angle sensor 5P connector (B) from the combination switch assembly/cable reel (C).






5. Remove the wire harness (D) from the harness holder (E).

6. Disconnect the cable reel connector A (20P), the cable reel connector B (4P), and the wiper/washer switch 8P connector (C) from the combination switch assembly/cable reel (D).





7. Remove the wire harness (E) from the harness holder (F).

8. Remove the combination switch assembly/cable reel mounting screws (A), then remove the combination switch assembly/cable reel (B) from the steering lock.





9. Remove the cable reel Service and Repair.

10. Remove the combination light switch (A) and the wiper/washer switch (B) from the combination switch body assembly (C).

NOTE: When installing the cable reel, set the turn signal canceling sleeve position so that the arrow points (D) straight up.





11. Install the combination switch body assembly in the reverse order of removal, and note these items:

NOTE:

- Do not remove the steering angle sensor from the combination switch body assembly.
- Tighten the combination switch assembly/cable reel mounting screws in the proper sequence.