P0460

DTC P0460 FUEL LEVEL SENSOR





Component Description





The fuel level sensor is mounted in the fuel level sensor unit.
The sensor detects a fuel level in the fuel tank and transmits a signal to the "unified meter and A/C amp.". The "unified meter and A/C amp." sends the fuel level sensor signal to the ECM via the CAN communication line.
It consists of two parts, one is mechanical float and the other is variable resistor. Fuel level sensor output voltage changes depending on the movement of the fuel mechanical float.
- Fuel level sensor unit and fuel pump (1)
- Fuel pressure regulator (2)
- Fuel tank temperature sensor (3)




On Board Diagnosis Logic

NOTE:
- If DTC P0460 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
- If DTC P0460 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. P0607.
When the vehicle is parked, the fuel level in the fuel tank is naturally stable. It means that output signal of the fuel level sensor does not change. If ECM senses sloshing signal from the sensor, fuel level sensor malfunction is detected.









DTC Confirmation Procedure
1. If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
a. Turn ignition switch OFF and wait at least 10 seconds.
b. Turn ignition switch ON.
c. Turn ignition switch OFF and wait at least 10 seconds.
2. Start engine and wait maximum of 2 consecutive minutes.
3. Check 1st trip DTC.
4. If 1st trip DTC is detected, go to P0460.




Diagnosis Procedure
1.CHECK DTC WITH "UNIFIED METER AND A/C AMP."
.
OK or NG
OK - GO TO 2.
NG - Go to Fuel Level Sensor Signal Inspection.
2.CHECK INTERMITTENT INCIDENT
Diagnosis Procedure.
- INSPECTION END




Removal and Installation

FUEL LEVEL SENSOR
Component.