Ignition Coil: Service and Repair

Ignition Coil-On-Plug

Removal
1 Remove the cover and disconnect the battery ground cable. For additional information, refer to Specifications [1][2]Battery
2 Remove the engine cover. For additional information, refer to Engine Cover Service and Repair




3
NOTE:
Left hand engine bank only.
Remove the dipstick.




4 Remove the ignition coil cover.
- Release from the 2 clips.




5 Disconnect the ignition coil-on-plug electrical connector.




6 Remove the ignition coil-on-plug.
- Remove the bolt.

Installation
1 Install the ignition coil-on-plug.
- Tighten the bolt to 6 Nm (4 lb.ft).
2 Connect and secure the electrical connector.
3 Install the ignition coil-on-plug cover.
- Position and secure the clips.
4
NOTE:
Left hand engine bank only.
Install the dipstick.
5 Install the engine cover. For additional information, refer to Engine Cover Service and Repair
6 Connect the battery ground cable and install the cover. For additional information, refer to Specifications [1][2]Battery