P1630

CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: P1630: Communication Error from VSC to ECM
P1630 - Communication Error from VSC to ECM

DESCRIPTION

The distance control ECU sends brake control request signals, warning request signals, etc. to the master cylinder solenoid (skid control ECU) through the ECM. Based on these signals, the brake actuator operates and the warning buzzer sounds. The master cylinder solenoid (skid control ECU) sends brake system malfunction signals, etc. to the ECM.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. REPLACE MASTER CYLINDER SOLENOID (SKID CONTROL ECU)

(a) Replace the master cylinder solenoid (skid control ECU) with a new one Removal.

NEXT -- Continue to next step.

2. CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)

(a) Using the Techstream, enter the following menus: Powertrain / Radar Cruise / Trouble Code.

(b) Clear the DTCs Dynamic Radar Cruise Control System.

(c) Perform the following to make sure the DTC detection conditions are met.

HINT
If the detection conditions are not met, the system cannot detect the malfunction.

(1) Drive the vehicle at a speed of 40 km/h (25 mph) or more.

(2) Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.

(d) Check for DTCs Dynamic Radar Cruise Control System.

OK:

DTC P1630 is not output.

NG -- REPLACE ECM Removal

OK -- END