Windshield Washer Spray Nozzle: Adjustments

WIPER AND WASHER: WIPER AND WASHER SYSTEM: PRECAUTION

NOTICE:
When disconnecting the negative (-) battery terminal, initialize the following system after the terminal is reconnected.





1. PRECAUTION OF WASHER NOZZLE ADJUSTMENT

(a) Do not clean or adjust the washer nozzle with a safety pin, etc. because:

(1) The washer nozzle tip is made of resin and could be damaged.

(2) Adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle. Adjustments

(b) In case the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.

WIPER AND WASHER: WASHER NOZZLE: ADJUSTMENT

1. ADJUST WASHER NOZZLE SUB-ASSEMBLY

(a) Using a screwdriver, disengage the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.





NOTICE:
Be careful not to damage the windshield.

HINT
Tape the screwdriver tip before use.

(b) Disconnect the washer nozzle sub-assembly from the washer hose.





NOTICE:
Washer nozzles cannot be reused.

(c) Select a washer nozzle sub-assembly so that the washer fluid spray area is within the standard.





(d) Connect the selected washer nozzle sub-assembly to the washer hose.

(e) Engage the 2 claws and install the washer nozzle sub-assembly.