Shifter CVT: Service and Repair

Removal and Installation

CVT-170 Components:

CONTROL CABLE COMPONENTS
Refer to the figure below for control cable removal and installation procedure.

CVT-171 Components:

REMOVAL





1. Push the knob cover downward and pull the lock pin out of the selector lever knob as shown.





2. Pull the selector lever knob (1) and knob cover (2) upward to remove them.
3. Pull up on the CVT finisher to release the clips and remove it.
4. Remove the front center console.





5. Remove the lock plate and disconnect the control cable from the control device.
6. Disconnect the control device harness connector.
7. Remove the control device assembly





^ <---: Bolt (4)

INSTALLATION
Note the following, and install in the reverse order of removal.





^ The knurled surface of rib should be upward when installing the control cable to the control device assembly. And insert the control cable securely
^ After installation is completed, adjust and check CVT position. Refer to CVT-172, "Adjustment of CVT Position" and CVT-173, "Checking of CVT Position".
Adjustments
Testing and Inspection