Shifter CVT: Service and Repair

Removal and Installation

CVT-171 Components:

CVT-172 Components:

REMOVAL

CAUTION:
Make sure that parking brake is applied before removal and installation.

1. Place the selector lever in the "P" position.
2. Remove the "P" center assembly.
3. Disconnect the CVT device harness connector.
4. Remove the key interlock cable from the control device assembly.
5. Remove the control cable from the control device assembly
6. Remove the nuts and the control device assembly.

INSTALLATION
Installation is in the reverse order of removal.





^ When installing the control cable (3) to the control device assembly (2), make sure that the control cable socket is fully pressed into the control device assembly (2), and the control cable end (1) is fully pressed in with the ribbed surface (A) facing towards the front of the vehicle.
<---: Vehicle front
^ After installation is completed, adjust and check the CVT position. Refer to CVT-173, "Adjustment of CVT Position" and CVT-173, "Checking of CVT Position".
Adjustments
Testing and Inspection
Selector Lever Knob Removal and Installation

REMOVAL

CAUTION:
Make sure that parking brake is applied before removal and installation.





1. Set selector lever knob (1) in "N" position.
2. Slide knob cover (2) downward.
3. Pull out lock pin (3) from selector lever knob (1).
4. Remove selector lever knob (1) and knob cover (2) as a set from selector lever.

CAUTION:
Do not push selector button.

INSTALLATION





1. Insert lock pin (3) to selector lever knob (1).
2. Install knob cover (2) to selector lever knob (1).
3. Set selector lever in "N" position.
4. Install selector lever knob over selector lever until a click is felt.

CAUTION:
^ Do not tilt selector lever knob when installing. Install it straight, and do not tap or apply any shock to install it.
^ Do not push selector button.