C1154

C1154 PNP SWITCH





Description
The transmission range switch signal is transmitted to the ABS actuator and electric unit (control unit) using the CAN communication lines.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.CHECK SELF DIAGNOSTIC RESULT
With CONSULT-III.
1. Turn the ignition switch OFF to ON.
2. Perform self diagnostic result.
Is DTC C1154 detected?
YES - Proceed to diagnosis procedure. C1154.
NO - Inspection End.




Diagnosis Procedure
1.CHECK DATA MONITOR
Select "SLCT LVR POSI" in "Data Monitor" and check transmission range switch signal.





Is the inspection result normal?
YES - Replace ABS actuator and electric unit (control unit). Removal And Installation VDC/TCS/ABS.
NO - GO TO 2
2.CHECK TRANSMISSION RANGE SWITCH
Perform transmission range switch inspection. CVT RE0F09B Transmission Range Switch A.
Is the inspection result normal?
YES - Replace ABS actuator and electric unit (control unit). Removal And Installation VDC/TCS/ABS.
NO - Repair or replace malfunctioning components.




Special Repair Requirement
1.ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
Always perform the neutral position adjustment for the steering angle sensor, when replacing the ABS actuator and electric unit (control unit). Service and Repair.
- END