LH&RH Front Anti-Pinch-Coupe

ENCODER:_:DRIVER SIDE

Description
Detects condition of the power window motor LH operation and transmits to main power window and door lock/unlock switch as pulse signal.

Component Function Check
1. CHECK ENCODER OPERATION
Check door glass LH perform AUTO open/close operation normally when operating main power window and door lock/unlock switch.
Is the inspection result normal?
YES - Encoder operation is OK.
NO - LH&RH Front Anti-Pinch-Coupe.

Diagnosis Procedure
Regarding Wiring Diagram information, Coupe With Left And Right Power Window Anti-Pinch.

Encoder Circuit Check
1. CHECK ENCODER OPERATION

1. Turn ignition switch ON.
2. Check signal between main power window and door lock/unlock switch connector and ground with oscilloscope.

Is the inspection result normal?
YES - Check intermittent incident. Intermittent Incident.
NO - GO TO 2
2. CHECK POWER WINDOW MOTOR LH POWER SUPPLY

1. Turn ignition switch ON.
2. Check voltage between power window motor LH connector and ground.

Is the measurement value within the specification?
YES - GO TO 4
NO - GO TO 3
3. CHECK HARNESS CONTINUITY 1

1. Turn ignition switch OFF.
2. Disconnect main power window and door lock/unlock switch and power window motor LH.
3. Check continuity between main power window and door lock/unlock switch connector (A) and power window motor LH connector (B).

4. Check continuity between main power window and door lock/unlock switch connector (A) and ground.

Is the inspection result normal?
YES - Replace main power window and door lock/unlock switch. LH & RH Front Anti-Pinch Coupe. After that, LH&RH Front Anti-Pinch-Coupe.
NO - Repair or replace harness.
4. CHECK GROUND CIRCUIT

1. Turn ignition switch OFF.
2. Disconnect power window motor LH.
3. Check continuity between power window motor LH connector and ground.

Is the inspection result normal?
YES - GO TO 6
NO - GO TO 5
5. CHECK HARNESS CONTINUITY 2

1. Disconnect main power window and door lock/unlock switch.
2. Check continuity between main power window and door lock/unlock switch connector (A) and power window motor LH connector (B).

3. Check continuity between main power window and door lock/unlock switch connector (A) and ground.

Is the inspection result normal?
YES - Replace power window motor LH. Removal And Installation. After that, LH&RH Front Anti-Pinch-Coupe.
NO - Repair or replace harness.