60051900 Removing and installing sunroof

WM 600519 Removing and installing sunroof

Technical values





Preliminary work

1. Remove headliner. -> 708419 Removing and installing headliner - section on "Removing" Service and Repair

Removing sunroof





Installation position of sunroof

NOTICE

Sliding-roof frame removed/fitted incorrectly

- Risk of damage to seats

-> Fold rear seat assembly over and tilt the front-seat backrests back.

1. Pull off water drain hoses.
1.1. Pull front water drain hoses -2- off the connection piece -1-.





Pulling off front water drain hoses

1.2. Pull rear water drain hoses -2- off the connection piece -1-.





Pulling off rear water drain hoses

2. Release plug connection for sunroof motor -2- ( -a- ) and pull it off -B-.





Disconnecting plug connection from motor

3. Loosen the sunroof. (Get another person to hold the sunroof to prevent it from falling down)
3.1. Unscrew front fastening screws -2- for the sunroof -1- from the outside in.





Loosening front sunroof attachment point

3.2. Unscrew side fastening screws -2- for the sunroof -1-.





Loosening sunroof attachment point at the sides

3.3. Remove the sunroof with the help of another person and pull it out of the passenger compartment through the rear lid opening.

Installing sunroof

1. Place the sunroof in installation position.
1.1. Guide the sunroof through the rear lid opening into the passenger compartment with the help of another person.
1.2. Fit the sunroof on the roof frame.
1.3. Screw in fastening screws so that the frame for the sunroof can still be moved slightly.
1.4. Move the sunroof until the locating bores are free.
1.5. Position the sunroof -1- using the punches -2 and 3- with a diameter of => Diameter: 12 mm on the locating bores.





Fitting punches

2. Secure the sunroof.
2.1. Screw in front fastening screws -2- from the inside out => Tightening torque: 8 Nm (6 ftlb.).





Securing sunroof at the front

2.2. Screw in side fastening screws -2- from front to rear => Tightening torque: 8 Nm (6 ftlb.).





Securing sunroof at the sides

2.3. Remove the punches -2 and 3- from the sunroof -1-.





Removing punches

3. Connect plug connection for sunroof motor -2-.





Connecting plug connection to motor

4. Secure water drain hoses.
4.1. Connect front water drain hoses -2- to the connection piece -1-.





Connecting water drain hoses at the front

4.2. Connect rear water drain hoses -2- to the connection piece -1-.





Connecting water drain hoses at the rear

4.3. Check that the water drain hoses are seated securely.

Subsequent work

1. Install headliner. -> 708419 Removing and installing headliner - section on "Installing" Service and Repair
2. Teach the end position. -> 6006AN Teaching the roof system - section on "Teaching" 6006AN Teaching roof systems