Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: INSTALLATION; 2013 MY FR-S [03/2012 -]

1. INSTALL SPIRAL CABLE SUB-ASSEMBLY

(a) Align the 2 pins and 2 guides, and engage the 6 claws to install the spiral cable sub-assembly to the steering sensor.









NOTICE:
Do not rotate the steering sensor until the spiral cable has been attached to it.

2. ALIGN FRONT WHEELS TO FACE STRAIGHT AHEAD

3. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NOTICE:
* Do not replace the spiral cable sub-assembly with the battery connected and the ignition switch on (IG).
* Do not rotate the spiral cable sub-assembly without the steering wheel with the battery connected and the ignition switch on (IG).
* Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Check that the front wheels are facing straight ahead.

(d) Set the turn signal switch to the neutral position.

NOTICE:
If it is not in the neutral position, the turn signal switch pin may snap.

(e) Engage the 3 claws to install the spiral cable with sensor sub-assembly.

(f) Connect the each connector.

4. INSTALL UPPER STEERING COLUMN COVER Installation

5. INSTALL LOWER STEERING COLUMN COVER Installation

6. INSTALL UPPER INSTRUMENT PANEL METER ORNAMENT Installation

7. INSTALL METER HOOD SUB-ASSEMBLY Installation

8. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation

9. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

10. INSTALL INSTRUMENT SIDE PANEL Installation

11. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NOTICE:
Do not adjust the spiral cable sub-assembly with the battery connected and the ignition switch on (IG).

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Check if the spiral cable sub-assembly is centered.









HINT
When the spiral cable is attached in a central position, it will align with the matching mark, allowing the colored area indicated in the illustration to be checked.

(d) If the spiral cable sub-assembly is not centered, center it.

NOTICE:
Do not turn the spiral cable sub-assembly using the airbag wire harness.

(1) Rotate the spiral cable sub-assembly counterclockwise slowly by hand until it stops.





(2) Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to the position where the matching mark is matched.









HINT
* The spiral cable sub-assembly will rotate approximately 2.5 turns to both the left and right from the center.
* When centering is not possible, there may be an open circuit in the spiral cable. Replace the spiral cable and steering sensor with new ones.

12. INSTALL STEERING WHEEL ASSEMBLY

Installation

13. PERFORM MEMORIZATION

HINT
Perform VSC sensor neutral memorization Programming and Relearning.

14. INSPECT SRS WARNING LIGHT

Diagnosis System