970909 Loosening and securing main wire harness in luggage compartment at the right
WM 970909 Loosening and securing main wire harness in luggage compartment at the right
Technical values
Information
The main wire harness is manufactured individually depending on equipment.
- Fastening elements may be different from the parts described.
- The number of plug connections can vary, depending on equipment.
Preliminary work
1. Disconnect the battery. -> 2X00IN General information on disconnecting the battery Procedures
2. Remove rear right luggage compartment side-panel lining. -> 700319 Removing and installing side-panel lining for rear luggage compartment - section on "Removing" Service and Repair
3. Remove luggage compartment trim (luggage compartment cover). -> 700619 Removing and installing luggage compartment trim panel (luggage compartment cover) - section on "Removing"
4. Remove right tail light. -> 943119 Removing and installing tail light - section on "Removing" 943119 Removing and installing tail light
5. Remove headliner. -> 708419 Removing and installing headliner - section on "Removing" Service and Repair
6. Remove rear right wheel housing liner. -> 536919 Removing and installing rear wheel housing liner - section on "Removing" Service and Repair
Loosening main wire harness in luggage compartment at the right
NOTICE
Voltage peaks
- Risk of damage to load or to the control unit
-> Switch off ignition and remove remote control before disconnecting or removing load.
Information
Always comply with the regulations for handling ESD-sensitive components!
- Assembly work must only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche.
- The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed.
- Never touch the electric pins and plug contacts.
Connector for main wire harness in luggage compartment at the right
1. Release and unplug electric plug connection -1- for seat-belt pretensioner. -> 691219 Removing and installing rear three-point belt - section on "Removing" 691219 Removing and installing rear three-point belt
2. Remove control unit for rear-end electronics. -> 578919 Removing and installing control unit for rear-end electronics - section on "Removing" 578919 Removing and Installing Control Unit for Rear-end Electronics
3. Release and unplug electric plug connection -3- for head airbag unit. -> 696619 Removing and installing head airbag unit - section on "Removing" 696619 Removing and installing head airbag unit
4. Release and unplug electric plug connection -4- for levelling system control unit. -> 431619 Removing and installing levelling system control unit - section on "Removing" Service and Repair
5. Release and unplug electric plug connection -6- for parking brake control unit. -> 466219 Removing and installing parking brake control unit - section on "Removing" 466219 Removing and installing control unit for parking brake
6. Release and unplug electric plug connection -7- for tail light. -> 943119 Removing and installing tail light - section on "Removing" 943119 Removing and installing tail light
7. Release and unplug electric plug connection -8- for loudspeaker amplifier. -> 914419 Removing and installing loudspeaker amplifier - section on "Removing" 914419 Removing and installing loudspeaker amplifier
8. Release and unplug electric plug connection -9- for filler flap actuator. -> 553819 Removing and installing actuator for filler flap - section on "Removing" Service and Repair
9. Release and unplug electric plug connection -10- for ground strap of tank filler neck. -> 201019 Removing and installing fuel tank - section on "Removing" Removal and Replacement
10. Unscrew fastening nut from ground point -11- behind the wheel housing.
11. Release and unplug electric plug connection -12- for trailer hitch control unit. -> 669619 Removing and installing trailer hitch control unit - section on "Removing" 669619 Removing and installing trailer hitch control unit
12. Release and unplug three electric plug connections -13- for connection point on wheel housing.
13. Release and unplug two electric plug connections -14- for connection point on tailgate. -> 972719 Removing and installing wire harness for tailgate - section on "Removing" 972719 Removing and installing wire harness for tailgate
14. Release and unplug electric plug connection -15- for rear interior light.
Fastening points in the luggage compartment at the right
15. Loosen fastenings -1- on wheel housing.
16. Press rubber sleeve -2- for line to tail light inwards.
17. Press rubber sleeve -3- for ground strap of tank filler neck inwards.
18. Loosen fastening -4- for ground strap of tank filler neck.
19. Loosen fastenings -5- for line to rear lid wire harness.
Securing main wire harness in luggage compartment at the right
Connector for main wire harness in luggage compartment at the right
1. Installation is performed in reverse order.
2. First lay the main wire harness loosely in the engine compartment, ensuring that it is positioned correctly.
Fastening points in the luggage compartment at the right
3. Fit fastenings -1, 5- and rubber sleeves -3-.
4. Tighten fastening nut on ground point -11- to => Tightening torque: 9 Nm (6.5 ftlb.).
5. Plug in electric plug connections -1 - 15- until they engage securely.
Subsequent work
1. Install rear right luggage compartment side-panel lining. -> 700319 Removing and installing side-panel lining for rear luggage compartment - section on "Installing" Service and Repair
2. Install luggage compartment trim panel (luggage compartment cover). -> 700619 Removing and installing luggage compartment trim panel (luggage compartment cover) - section on "Installing"
3. Install the tail light. -> 943119 Removing and installing tail light - section on "Installing" 943119 Removing and installing tail light
4. Install headliner. -> 708419 Removing and installing headliner - section on "Installing" Service and Repair
5. Install rear right wheel housing liner. -> 536919 Removing and installing rear wheel housing liner - section on "Installing" Service and Repair
6. Connect the battery. -> 2X00IN General information on disconnecting the battery Procedures